This is BEFORE. I purchased the faux steel adhesive foil over a year ago when I painted my kitchen cabinets. Today was the day to tackle this project.
First I removed the panel from the dishwasher. This required removing a cabinet door also to get to the bottom screw on the dishwasher.
Then I cleaned both panels (door and bottom) with a cleaning solution and finally a vinegar and water solution (window cleaner).
Measured and cut bottom section first.
Per directions, I sprayed water on piece I was covering and applied the faux steel product.
That went pretty well!
Next, the door panel. This was a little more challenging. I did not have a squeege, so I used a plastic spatula. It worked ok.
I'm satisfied with the results! My babe just came over and he wants to redo it. The door panel does have a few "bubbles" and he wants to get them out. Not today though. I do have enough left to again. Perhaps he'll do it tomorrow? This compliments my refrigerator and stove for a fraction of the cost of a new dishwasher. I don't even USE my dishwasher! And it works perfectly! I do run a cycle probably once a month just to make sure it works!